H7: ASME BPV Code Section VIII, Division 1: Workshop Design Calculation

Description:

ASME Code vessels don't always have to be "fatter"! Following a brief general introduction into the ASME Code, the participants will be made familiar with the applicable ASME Code Section VIII, Division 1 design requirements. Many different practical examples and exercises will offer a deep insight into the ASME Code specific design rules. During the course, the participants will calculate typical pressure components on their own, assisted by an experienced design engineer who is also an Authorized Inspector Supervisor. 
Having attended this course the applicants have the necessary basic knowledge to perform their own design calculations and/or review such calculations for Code compliance. 

The seminar language is English.
 

Overview of the topics:

• ASME Code - general introduction, Code Cases, Interpretations

• Structure of Section VIII, Division 1

• Design basics: determining the specific Section VIII, Division 1 design data (MAWP, design pressure, test pressure, design temperature, MDMT, seismic and wind loads, external nozzle loads, etc.)

• Material (ASME, ASTM, EN) and establishing the allowable stress values as listed in ASME Code Section II

• Joint categories, types and efficiency factors E and the corresponding scope of nondestructive examination

• Calculation of cylinders and cones, dished heads and flat covers, for internal and external pressure

• Nozzles (reinforcement, large openings, external nozzle loads, UG-45, etc.)

• Dimensioning flanges according to Appendix 2 and ASME B16.5

• Vessel supports (saddles, lugs, skirts)

• Special services UW-2 (lethal service, direct firing, low temperature service)

• Finite element analysis in Section VIII, Division 1

• Fatigue analysis requirements for Division 1 vessels

• Impact test requirements as an integral design element

• Proof test to establish the maximum allowable working pressure in VIII-1

• Calculations using non-ASME procedures/formulas covered by par. U-2(g) of Section VIII-1 (e.g. FEA, British Standard, AD 2000, EN13445, etc.)

• Pressure testing requirements of Division 1